Page 8
Installation and connection
The product must be installed in accordance
with all local electrical regulations.
Plug the power cable into the socket.
Installing the product
1.
Prepare the counter according to the
installation dimensions in the user manual.
2.
In order to avoid foreign substances
and liquids penetrating between the hob and
the counter, please apply the putty supplied
in the package to the contour of the housing
in the counter before installation, make sure
that the putty does not overlap.
3.
Place the hob onto the counter so that
the control buttons face forwards you.
DANGER
Before starting any
work on the electrical installation,
disconnect the product from the
mains supply.
There is the risk of electric shock!
Power cable plug must be within
easy reach after installation (do
not route it above the hob).
DANGER
The product must be
connected to the mains supply
only by an authorised and
qualified person. The product's
warranty period starts only after
correct installation. The
manufacturer shall not be held
responsible for damages arising
from procedures carried out by
unauthorised persons.
DANGER
The power cable must
not be clamped, bent or trapped
or come into contact with hot
parts of the product.
A damaged power cable must be
replaced by a qualified
electrician. Otherwise, there is
risk of electric shock, short circuit
or fire .
Electrical connection
Connect the product to a grounded outlet/
line protected by a fuse of suitable capacity
as stated in the "Technical specifications"
table. Have the grounding installation made
by a qualified electrician while using the
product with or without a transformer. Our
company shall not be liable for any damages
that will arise due to using the product
without
a
grounding
installation
in
accordance with the local regulations.
1
Minimum of 50 mm
Connection must comply with national
regulations.
The mains supply data must correspond to
the data specified on the type label of the
product. Type label is at the rear housing of
the product.
Power cable of your product must comply
with the values in "Technical specifications"
table.
When installing the hob onto a
cabinet, a shelf must be installed
in order to separate the cabinet
from the hob as illustrated in the
figure. This is not required when
installing onto a built-in oven.
If it is possible to touch the
bottom of the hob once it has
been installed, then this exposed
area must be covered with a
wooden board.
