Page 10
x
Insert the oven into the cupboard.
x
Open the door to expose the fixing holes in the side trims.
x
Secure the oven by 4 countersunk screws (fasteners are not supplied).
Oven installation
Installation and connection
The appliance must be installed in
accordance with all local gas and electrical
regulations.
Electrical installation
This appliance must be earthed and the
manufacturer and the seller do not accept
responsibility for any damage due to
incorrect installation or electrical connection.
This appliance should not be connected
through an earth leakage system.
Refer to S.A.N.S.10142.
APERTURE
1085 H x 700 W x 590 D
1085
Aperture
Typical section showing
ventilation requirements
Aperture
1085 H x 700 W x 580 D
700
600
Above floor
level
Floor
60
+
_3
0
+
_3
0
+
_3
0
+
_3
0
Aperture
32
32
x
Support the oven in front of the aperture
and make the electrical connection before
installing. This will ensure enough cable
length for subsequent servicing.
x
Slide the oven fully into the cabinet before
securing it.
100 MIN
x
Fixing holes are located on the side trims.
Secure the oven by inserting small wood
screws through these holes into the cabinet
side wall. (screws are not provided).
x
It is adequate to only secure the unit on one
side. (same side as the handle).
100 MIN
Connection to the power supply
The connection must be carried out by a
licensed electrician, who will ensure that the
oven is correctly connected and safely
earthed. The rated current is printed on the
serial number label attached to the oven side
trim.
The appliance must be connected to the
mains through a double pole isolating switch
which has a minimum clearance between the
contacts of 3 mm. in both poles.
A means for disconnection must be provided
in the fixed wiring.
Aperture
1085 H x 700 W x 580 D
