Defibtech RMU-1000, User Manual

Page: 22 / 65

The Compression Module (continued)
To attach the Compression Module to the Frame, perform the following steps:
• Attach the Frame to the Backboard (described in Section 3.4).
• Insert the locking sleeve of the Compression Module into the module receptacle of the
Frame as shown below. The Module should be inserted at approximately 90 degrees to
the Frame at which point it should rest in the Frame. Rotate the Module in either direction
until it is in line with the Frame and snaps to lock into place. When properly attached, the
Compression Module should be securely attached to the Frame.
Locking
Sleeve
Module
Receptacle
To remove the Compression Module from the Frame, push down on the Compression Module
and then rotate it approximately 90 degrees to either direction. The Compression Module can
then be lifted out of the Frame. Be careful not to drop the Module.
RAC-E1510EN-DN
22