10
Care and Cleaning
Ƒ
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
Ƒ
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
Ƒ
Do not spray the light fixture with a hose or power washer.
Troubleshooting
Problem
Possible Cause
Solution
The light will not come on.
Ƒ
The light switch is turned off.
Ƒ
Turn the light switch on.
Ƒ
The fuse is blown or the circuit breaker
is turned off.
Ƒ
Replace the fuse or turn the
circuit breaker on.
Ƒ
Daylight turn-off (photocell) is in effect.
Ƒ
Recheck after dark.
Ƒ
The circuit wiring is incorrect (if this is
a new installation).
Ƒ
Verify the wiring is correct.
Ƒ
The motion sensor is aimed in the
wrong direction.
Ƒ
Re-aim the motion sensor
to cover the desired area.
Ƒ
The outside air temperature is close to
the same as a person’s body heat.
Ƒ
Increase the “SENS”
setting.
The light comes on during the
day.
Ƒ
The motion sensor may be installed in a
relatively dark location.
Ƒ
The light fixture is operating
normally under these
circumstances.
Ƒ
The “ON-TIME” switch is in the “TEST”
position.
Ƒ
Set the “ON-TIME” switch
to the 1, 5, or 20 minute
setting.
The light comes on for no
apparent reason.
Ƒ
The motion sensor may be sensing
small animals or automobile traffic.
Ƒ
Decrease the “SENS”
setting or reposition the
motion sensor.
Ƒ
The “SENS” switch is set too high.
Ƒ
Decrease the “SENS”
setting.
Ƒ
The “DUALBRITE” switch is in the 3
hour, 6 hour, or dusk-to-dawn setting.
Ƒ
The light fixture is operating
normally under these
circumstances.
Ƒ
The outside temperature is much
warmer or cooler than a person’s body
heat (summer or winter).
Ƒ
Decrease the “SENS”
setting.
Ƒ
The light fixture is wired through a
dimmer or timer.
Ƒ
Do not use a dimmer or
timer to control the light
fixture. Replace the dimmer
or timer with a standard on/
off wall switch.
The lights turn off too late in the
Dusk-to-Dawn setting.
Ƒ
The light fixture may be installed in a
relatively dark location.
Ƒ
Relocate the light fixture
or use the 3 hour or 6 hour
setting.
