5 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Installation
1
Determining the mounting
location
NOTE:
The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground. If the light fixture is
mounted higher than recommended, aiming the sensor
down will reduce the coverage area.
Ƒ
Determine the mounting location.
Ƒ
Position the lamp heads (A) in the general
direction of the desired light coverage.
Ƒ
If needed, rotate the motion sensor (C) so the
controls face the ground after installation.
Wall Mount
Eave Mount
2
Removing the 1-2- asy
Connect™
NOTE:
This fixture comes with a 1-2- asy Connect™ (D).
It is pre-assembled on the light fixture (B) for shipping.
NOTE:
The large mounting bolt (EE) is pre-installed in
the light fixture (B). Do not attempt to remove the large
mounting bolt (EE).
Ƒ
Unscrew the large mounting bolt (EE) connecting
the light fixture (B) to the 1-2- asy Connect™ (D)
and remove the 1-2- asy Connect™ (D).
NOTE:
Ensure rubber gasket is on the 1-2- asy
Connect™.
GN
D
L (Black
)
N (White)
UP/Haut/Arriba
3
Installing the mounting bracket
WARNING:
Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
NOTE:
Six mounting bracket screws of various sizes are
included. The installation will only require two. Discard the
unused mounting bracket screws after installation.
Ƒ
Remove the existing light fixture.
Ƒ
Install the mounting bracket (GG) with the
stamped word “FRONT” facing away from the
junction box. Use the mounting bracket screws
(BB, CC, or DD) that best fit the junction box.
Ƒ
Firmly pull on the mounting bracket to verify
it is securely mounted to the junction box. If
necessary, use the screws that were removed
from the existing light fixture.
FR
ON
T
FR
ONT
A
C
EE
D
B
BB, CC, or DD
GG