DEFENDERTECH DT-200Turbo, Installation And Maintenance Manual

Page: 43 / 50

~ 9 ~
Operation Spy Lights
ARM: Flashing = “ DISARMMED device” – Light on steadily = “ ARMED ”
HEAT: Light on steadily = “ HEATING ” – Flashing = “ READY TO SHOOT ”
LOW: Flashing = “ RESERVE ” (1 minute available) – Light on steadly = “ FINISHED LIQUID ”
FAULT (blu): 3 Flashes = “ Battery Fault ” - 4 Flashes = “ Probe Fault ”
5 Flashes = “ Power Lack ” - 6 Flashes = “ Overheating Burner ”
8 Flashes = “ Burner Resistance Fault ”
BAT: Turned off = “OK” – 1 Flash per second = “ Discharge ” - 3 Flashes = “ Absent or Faulty ”
Input-Output Connection
IN + 12V
-
Mandatory input of 12V DC from an external source (central or accessory DT-POWER200).
The maximum absorption during the firing phase is 350 mA, if your control panel is not able to supply this
power, it is necessary to equip the device with the DT-POWER200 accessory, which is composed by a "battery
charger" power supply, 12V backup battery and fixing bracket, thus making the appliance energetically
autonomous.
COM
Common terminal of negative polarity (-12V) to be used for interaction with the ARM and FOG terminals.
ARM (N.O. by default - adjustable to N.C. with the "
I
" Jump)
By bringing to this input the continuous signal taken from the COM terminal, it will follow the "arming" of
the device. The "ARM" LED will switch from flashing (which means Stand By) to Light on Steadily (wich means
Armed), while the "HEAT" LED (heating) will light up.
The burner will be 100% ready to deliver after 15-20 minutes (it depends on the room temperature or how
long
it has been disarmed) and when it will be, the "Heat" LED will flash.
It is possible to change the activation mode of all the inputs and outputs from "N.O." (by default) to "N.C."
by removing the "I" Jumper.