PHOENIX1
10
PHOENIX1
POWERING ON
Turn on the monitor by pressing the . You will hear an audible beep and the LED lights will blink. The screen will
display video from your mounted camera.
The red LEDs at the top of the monitor indicate the level of sound the microphone is detecting. The first two lights
indicate a quiet sound level, the middle light indicates moderate, and the fourth and fifth lights indicate loud sounds
taking place in the area you are monitoring.
To adjust microphone sensitivity, use the
on the side of the LCD monitor. Turning the up causes the camera
to become more sensitive to sound and prone to more frequent alerts on the monitor. Turning the down causes
the camera to be less sensitive towards sound and will only alert you in instances of very loud
noises. The LEDs at the top of the monitor will still blink to indicate the level of noise occurring in
your monitoring location.
You can also adjust the level of audio volume on your LCD monitor. Press the V+ button to make
the audio louder or press the V- button to turn down the volume.
OPERATING MODES
The system can be set to operate in one of three modes: Scan, Auto, or Manual. The desired
operating mode can be selected using the buttons on the front panel of the LCD monitor.
Note: Two cameras are required to operate in Auto mode.
MANUAL MODE
Pressing the M button places the system in Manual mode. In this mode, the monitor will display
continuous video and audio on your LCD screen and alert you with a beep when any loud sounds
occur in the area you are monitoring. To disable this alert, turn down the
(audio
sensitivity) dial on the side of the monitor by turning the dial down all the way.
