56
EN
3 /USING YOUR APPLIANCE
TURNING ON THE COOKING ZONES
AND ADJUSTING THE POWER
— Select
the burner that you wish to use by
placing your finger squarely on the
corresponding touch control
(fig. 01).
➡
The selected power display shows a
flashing .
— Choose
the heating power by pressing on
the touch controls:
➡
sets power level
(max)
(Fig. 02).
➡
sets power level
(min)
(Fig. 03).
➡
Sets power level
(Fig. 04).
➡
Sets power level
(Fig. 05).
The hob turns on automatically. You can ad-
just the power of the cooking zone by press-
ing the touch controls
or
.
— Locking:
press the control
(Fig. 06): you
will hear a beep. Hold you finger down for
about 3 seconds: you will hear 2 beeps and
the indicator lights up.
The controls are locked, except for the on/off
control
and the overall off touch control.
— Unlocking:
press and hold for about
3 seconds the touch control
(Fig. 06).
The indicator goes out. The hob returns to
all the confirmed settings.
— Overall off:
You can turn off any operating
gas burners immediately by pressing the
overall off touch control
. This cancels the
lock if this was in operation.
•
Fig. 01
Fig. 02
Fig. 03
Fig. 04
Fig. 05
Fig. 06
After intensive use, the cooking area may
remain hot for a few minutes.
An “
H”
H” is displayed to warn users. Do not
touch the zones concerned during this time.
•
Residual heat indicator
Tip
- The flames of the gas burner are
smaller near the support to protect the
enamel.
Note
- If the flames go out accidentally (e.g.
due to a gust of air), your hob is equipped
with an automatic relighting system. This is
limited to 2 re-lightings separated by
10 seconds.
- The minimum ambient temperature for use
is 10°C to ensure optimal functionning of the
tap.
Summary of Contents for DTG 1138 Series
