DeDietrich DOP 450 XE1, Manual

Page: 44 / 156

What do you do in case of operating malfunctions?
If you have a doubt about the functioning of your oven, this does not nec-
essarily mean that there is a malfunction. In any event, check the following
items:
Y
ou notice that...
P
ossible causes
W
hat should you do?
The oven is not heating.
• The oven is not connected.
• The fuse in your electrical set-up is
not working.
• The selected temperature is too
low.
- Connect the oven.
- Replace the fuse in your electrical
set-up and check its capacity (16A).
- Increase the selected temperature.
The temperature indicator is flashing. • Problem with the door's lockinmechanism. - Call the After Sales Service Department.
The oven light is not working.
• The light is out of order.
• The oven is not connected or the
fuse is not working.
- Replace the light.
- Connect the oven or replace the
fuse.
The pyrolysis cleaning cycle does
not begin.
• The door is not properly closed.
• The locking system is defective.
- Verify that the door is locked.
- Call the After Sales Service Depart-
ment.
Your oven starts beeping.
• During cooking.
• At the end of a cooking
programme.
- The recommended temperature
of your choice has been reached.
- Your programmed cooking cycle is
finished.
Your oven displays
Réglages
+ -
• When the touch controls are
pressed.
• Controls are locked for child safety.
- Working normally.
- To cancel the lock, hold down the
Stop touch control until the symbol
disappears.
• The bulb is located on the ceiling of your oven's cavity.
a) Unscrew the view port (see adjacent
diagram).
b) Remove the bulb.
Bulb specifications:
- 25 W
- 220-240 V
- 300°C
- G9
c) Replace the bulb then reposition the
view port and reconnect your oven.
Disconnect your oven before performing any task on the bulb to
avoid the risk of electric shock and, if necessary, let the appliance
cool down.
H
ow do you change the bulb?
Bulb
Unscrew
View port
44
99633803_ML_A.qxd 06/06/05 10:07 Page 44