e n g l i s h
If you have a doubt about the correct functioning of your oven, this does not necessarily mean that
there is a malfunction. In any event, check the following items:
Warning
Repairs to your appliance should only be made by a professional. Non-standard repairs
may be a source of danger for the user. In all circumstances, if you cannot deal with a
problem yourself, contact the after-sales service department without delay.
* Only for models with the pyrolysis function.
You observe that:
Possible causes:
What should you do?
The oven is not heating.
- The oven is not connected to
the power supply.
- Your fuse is out of order.
- The selected temperature is
too low.
- “DEMO” mode is active.
- Connect the oven.
- Replace the fuse in your electrical
set-up and check its capacity (16A).
- Increase the selected temperature.
- Exit “DEMO” mode.
*The padlock is flashing.
- Problem with the door’s
locking mechanism.
- Call the After-Sales Service
Department.
The oven light is not
working.
- The light is out of order.
- The oven is not connected or
the fuse is not working.
- Replace the bulb.
- Connect the oven or replace the
fuse.
*The pyrolysis cleaning
cycle does not begin.
- The door is not properly
closed.
- The locking system is
defective.
- Verify that the door is locked.
- Call the After-Sales Service
Department.
Your oven starts beeping.
- During cooking.
- At the end of a cooking cycle.
- The temperature recommended for
your choice has been reached.
- Your programmed cooking cycle is
finished.
The cooling fan continues
to operate after the oven
stops.
- The fan should work for a
maximum of one hour after
cooking, or when the oven
temperature is greater than
125°C.
- If it does not stop after 1
hour
- Open the oven door to cool down
the oven faster.
- Call the After-Sales Service
Department.
TROUBLESHOOTING
Problems &
Solutions
Summary of Contents for DME1140B
Page 1: ......
