Adventus
User manual
Sida 13/18
Mechanical settings
2. Fold up the locking lever (A) to open the front
attachment (C).
3. Loosen the screw (K) on the underside of the
frame.
Loosen the locking screws (L) and move the
front attachment (C) as far back as possible.
4. Loosen the locking screws (M) and move the
rear attachment (B) as far back as possible.
5. Loosen screws (N) and the adjustment screw
(O) so that the screws (N) kan move freely
inside the track for angle adjustment (E).
6. Put the wheel in its front position, put
Adventus in place on the footrest by inserting
the attachment (B) so that it locks into the
rear tube of the footrest.
Lower the wheel to the ground level and lock
the front tube of the footrest by folding down
the locking lever (A).
Tighten the screw (K) until the front
attachment (C) locks against the footrest.
Tighten the locking screws (L).
7. Press the rear attachment (B) back with your
hand so that it locks against the rear tube of
the footrest.
Tighten the locking screws (M).
8. Adjust the adjustment screw (O) until the
wheelchair´s front castors are just lifted from
the ground. Tighten the screws (N) on both
sides.
9. Turn the wheel to its rear position and check
that the front castors lift from the ground.
Recomended height is 30-40mm.
If the front castors are not lifted enough from
the ground then, if possible, move the wheel
to a higher position in the fork. If the wheel
position is changed the adjustment screw (O)
and screws (N) must be loosened again to
remake the adjustment from item 8.
A
B
C
K
M
L
N
O
E
Summary of Contents for Adventus
Page 1: ...Adventus User manual 2021 06 Rev1...
Page 2: ......
