decoflame Denver User Manual Download

Page: 10 / 16

FILLING THE FUEL TANK

ONLY ADULTS MAY OPERATE THE ELECTRONICS OF THE DECOFLAME DENVER BASIC™.

In order to open the fuel lid, the fireplace needs to be plugged into a power socket. Press the

button

for the lid to unlock . Open the lid of the fuel inlet, insert the funnel into the hole and fill in bioethanol.
Once the fuel tank is filled by three-quarters, you will hear an acoustic signal. This tone will increase in
intensity proportionally with fuel level. Once the tank is completely filled, the acoustic signal will become
constant. Similarly, the lines indicating the fuel level on the control panel will gradually increase indicating
to stop the filling process. Avoid spillage during filling. If you have spilled any bioethanol, use a paper
towel in order to wipe off thoroughly any spilled liquid around the fuel inlet.

Remove the funnel. Close the lid of the tank inlet. You can start the fire now by pressing the

button

on the control panel.

NB: When filling the fuel tank, the electronics of the fireplace have to be switched on, in order to detect
spillage.

NB: The ignition process will not start if any liquid is detected around the fuel inlet or if the lid for
the tank inlet is left open.

REFUELLING

The FUEL LEVEL lights will be blinking slowly when the tank will be empty.

DO NOT

switch the electronics of the fireplace off. Wait until the flame is completely extinguished and the

fireplace has cooled down (around 5-10minutes). When the the lights of the FUEL LEVEL indicator have
stopped blinking, you can start the filling process. Press the

button for 5 seconds for the lid to unlock.

Open the lid, insert the funnel in the hole and fill in bioethanol.

IGNITION

Press the

button on the control panel. After a short while, the first flames will appear around the

centre of the flame tray. Subsequently, it will take a short time until the fireplace will warm up and whole
width of the flame tray is filled with flames. Once the flame tray shows flames throughout its complete
width, the fire will be burning at a factory pre-set level. You can change the level by pressing the

buttons on the control panel. Once you have changed the flame level, please wait a couple of minutes
before you adjust it further downwards or upwards, in order to give the system the necessary time to
react to the changes made.

The control panel will go on stand-by (the lights on the control panel will turn off), if the flame level has
not been changed for three minutes. In order to re-activate the control panel, you simply need to press
the

button.

The flame level will automatically decrease and cannot be increased to the initial level within the next
15 minutes. During this process, the light on the control panel will be blinking within 10 seconds intervals.

ExTINGUISHING THE FLAMES

To switch off the fire at any time – also during the warming-up phase – press the

button on the control

panel. The flames will disappear within a few minutes. You can leave the electronics on stand-by without
pressing any further buttons now. You can also re-start the fire as described above immediately.

SwITCHING OFF

In order to switch off the electronics of the fire, switch the

button on the control panel.