Due to the high temperature of the fireplace surfaces, keep children and pets at a safe distance.
Do not use the unvented decorative fireplace to heat or boil water or use as a cooking appliance.
Do not use in a room with oxygen tanks.
Risk of Indoor Air Pollution – Use the unvented decorative fireplace only in a well-ventilated
area and with doors of adjacent rooms open. Do not obstruct air flow to the fuel holder box by
piling logs over
the fuel reservoir or in any other way with any other material. People with breathing problems
should consult a physician before using the unvented decorative fireplace.
The following or equivalent information for provision of combustion and ventilating air for un-
vented decorative devices: ‘’In a house of typical construction, that is, one that is not of un-
usually tight construction due to heavy insulation and tight seals against air infiltration, an
adequate supply of air for combustion and ventilation is provided through infiltration.” The
unvented decorative appliance should not be used in a small room where less than 5.7 m
3
(200
ft
3
)
of air space is provided for each 1000 Btu per hour of the unvented decorative device rating
(considering the maximum burner adjustment). Do not use the unvented decorative fireplace in
a bathroom, a room where sleeping accommodation is provided or any other small room.
Make sure that the shut off device works properly before lighting.
INSTALLATION OF THE WALL MOUNTED FIREPLACE AND BURNER
Models
ARC 103A & VAGUE 101A
are wall-mounted.
A horizontal support and two vertical supports are provided with the fireplace.
Determine the location of your fireplace. It must be located at a minimum of 12’’ above the
floor, at a minimum of 24’’ from the ceiling, and allow a clear distance of 12’’from the right and
left edge of the unit.
To attach the hanging support, refer to the drawing for installation
.
Locate 2 wall studs (obligatory), that are at 16’’ center to center.
Attach the horizontal support (no 1) using a bubble level tool with 2 no.12 x 1 ½’’ wood screws
(no.4).
Hang the 2 vertical straps (no.2) on the hooks of the horizontal support (no.1) and ensure that
they are square. Add brackets (no. 3) to the bottom of the vertical supports, attach them with
