DECKED.COM
|
#DECKEDUSA
|
@DECKEDUSA
MT5 / MT7 | v.1.1 |
Page 4
DETAIL A
Align shim to channel in floor shown 3” from
cabside panel of bed (red).
DETAIL B
Align shim to channel in floor shown. Place
shim 6 1/2” from rear of bed (red).
3”
6 1/2”
A
B
PLACE LARGE SHIM OVER FACTORY BED BOLT
AS SHOWN.
REPEAT PASSENGER SIDE.
➡
CAB
PREP BED:
SHIMS
•
2 SMALL
shims and
2 LARGE
shims (with holes) are loose in your hardware kit.
• Using the information below:
1) Clean the bed surface where the shims will be located. Isopropyl alcohol (do not drink) is recommended.
2) Remove tape film and apply shim with the strength of 1000 men a.k.a push really hard.
