G
ENESIS
-VP™: User’s Manual
6
Secondary menu
You may use the factory default settings listed below or you may select your
own settings. To select your own settings, press and hold the
SEL
(select)
button and then press the
MENU
button. You will see “Prt” (for
communication port) in the left window and a “O” (for none) in the right
window. If you wish to change this to an other mode of serial port
communication, then simply release and press the
SEL
(select) button. (The
SEL
button is used to toggle/cycle through all available values for a given
parameter.) Press the
MENU
button again to move to the next category and
repeat the process. When finished, release the buttons and your new settings
will be in effect. See section 2.3 on Menus for other settings.
Factory default settings:
Prt (communication port) ......... 0 = No serial communication
FSt (fastest vehicle style) .......... 1 = Fastest-toggle
tSt (test) .................................... off
You are now ready to measure the speed of targets.
Figure 3:
Secondary Menu
Master Reset
To reset all parameters (except the “tSt” setting) to their default values, press
and hold the
SEL
(select) button while pressing the
PWR
(power) button
when turning the unit ON. The unit will generate a long tone, reset all
parameters to the default values (see lists above), and continue powering up.
