Decatur Electronics Genesis II Select, User Manual & Installation Manual

Page: 31 / 72

G
enesis II S
elec
t
™
U
ser
’s
& Installa
tion Ma
nual
16/September/2015
31
5. Communication System Controls
You can configure the Genesis II Select™ through the serial
communications (COM) port on the rear panel to communicate
with PCs, speed signs, and in-car video systems, such as the Decatur
Electronics Responder 1000™ and the Decatur Electronics Vehicle
Interface Portal (VIP)™. The communications cable does not come
with your order and can be purchased separately from Decatur
Electronics or you authorized dealer. See Appendix A for the more
details on the serial communications port configuration.
6. Operating the Genesis II Select™
After you test and confirm that the unit is properly installed, it is
ready for use.
6.1 Power
The PWR button on the hand-held remote turns the Genesis II
Select™ on and off. After you press the PWR button, the display
illuminates and the computer checks the circuitry. If the power-up
checks pass, the computer displays TEST PASS in the MODE window.
If the power-up checks fail, a system error message (SYS) will display
in the MODE window and the unit will not respond to any control
except the PWR button to power down. Turn the unit off then back
on. If the error message persists, remove the unit from service and
contact Decatur Electronics or your authorized dealer.
t 8IFOUIF(FOFTJT**4FMFDU™JTQPXFSFEEPXOJUTUPSFT
the current settings. These settings are restored the
next time you power up the unit.
6.2 Front and Rear Antenna
At power up, the Genesis II Select™ antennas are in standby mode.
(Standby mode is when the antenna is not transmitting.) If no
antenna is connected to the unit, the FRONT and REAR lights cycle on
BOEPòBOE"OU EJTQMBZTJOUIF.0%&XJOEPX