Troubleshooting
The DecaLED
®
Controller 3 Mini does nothing.
Check that the device is connected to the socket via the supplied power cord and that it is switched
•
on.
Check that the red light on the power switch on the backside of the device is turned on. If not, remove the
•
device from the socket and change the fuse. This is located under a small lid near the power adapter.
Check that the Power LED is on. If not, return the device.
•
The DecaLED
®
Controller 3 Mini does not respond to DMX.
Check that the DMX control LED is on.
•
If the control LED is not on, check that DMX is present and/or that the connector is connected correctly.
•
Check that the DMX addresses have been set correctly by means of the DecaLED
•
®
Setup Tool.
The connected DecaLED
®
24V products do not respond.
Check that the output cables and all connections have been connected correctly. If necessary, remove
•
all outputs except 1.
Only a maximum loading capacity of 3A(1A per individual channel) is allowed on a single output and the
•
maximum amount of the total load can not exceed 4A distributed over all 2 outputs.
The DecaLED
®
Controller 3 Mini cannot be programmed.
Remove the DMX signal when connecting the DecaLED
•
®
Setup Tool.
Check the DecaLED
•
®
Setup Tool and its cables and connections.
Check the batteries or connect the supplied power supply to the DecaLED
•
®
Setup Tool.
If you cannot find a cause for a defect, we advise you to contact your supplier. Leave repairs to professionals.
Never try to repair the device yourself, as this could influence your warranty.
Info: www.lagotronics.com
