Dean CFD, Service And Parts Manual

Page: 33 / 100

DECATHLON SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-28
1.7.8 Replacing the Frypot
(cont.)
23.
Remove screw(s) securing the electronic or
standing pilot bracket to the frypot bracket.
Reposition ignitor assembly down and away
from frypot. Use care not to bend, kink, or
damage the electronic ignition lines and wiring.
NOTE: Remove the trailing pilot assembly on
current production models as follows:
a.
Disconnect the pilot supply line from the
trailing pilot valve on the burner manifold.
b. Remove the mounting screw(s) as described
in Step 23, then remove trailing pilot.
24. Remove cotter pin from drain valve linkage,
and disconnect actuator rod from drain valve
actuator. (Not applicable on 3” drain models.)
25. Remove elbow (tee-fitting on fryers equipped
with front manifold) and nipple from the drain
valve. (Not applicable on 3” drain models.)
26. If ball-retainer nut breaks loose and unscrews
from the valve, remove it from the elbow
nipple and re-install in valve. Use care not to
damage the brass threads when removing from
elbow nipple, or when re-installing into drain
valve.
Remove cotter pin (arrow), then disconnect the
actuator rod.
Ball retainer nut (arrow) on drain valve.
Removing electronic/standing pilot assembly.