HUMMER H1: STEP BY STEP
™
174
10
10
12
12
11
11
99
Applying pressure with your hands to keep the parts tight to
each other, tighten the set screw firmly with the Allen key.
As you have done in earlier stages, keep any unused parts in a
plastic bag, and mark the stage number for ease of reference.
Push the cup joint down so that it rests against the gear. If it is
difficult to push it, loosen the set screw a little.
Holding the Allen key so that its shorter arm is in the screw and
its longer arm is in your hand will make it easier to tighten, as you
are given greater leverage.
Place the cup joint and bearing assembly onto the tip of the main
shaft, as shown. Make sure that the flat portion of the shaft's tip
fits into the corresponding flattened section of the inside of the
joint (see arrow).
Assembled parts
