HUMMER H1: STEP BY STEP
™
186
99
13
13
11
11
15
15
12
12
16
16
10
10
14
14
Tighten the second 3
× 12mm binding-head
screw (Stage 39) into the
wider hole on the left side
of the pads and calipers,
and tighten lightly.
Place one of the steering
posts into the hole in the
center of the right servo
saver, from the side that
houses the spring.
Pull the servo savers apart
gently and place the
assembly directly behind
the front bulkhead from
the rear.
Prepare the steering plate and servo saver assembly built in Stage
26. The steering plate is in the middle, with the two servo savers
to the left and right.
The disc brake is
complete, and should
look like this.
Insert the other
steering post into the
hole in the left servo
saver from the same
side as you did the first.
From the side, your brake
pads and calipers should
look like this. Turn the
screws until there is a gap
of about 1mm between
the outermost caliper and
the screw head.
Push the steering post
through to the back of the
servo saver.
