41
CONNECTING THE SERVO CABLE
8
Take either end of the connector cable and carefully fit
it in one of the two sockets circled in red. It does not
matter which one. Gently push until it locks in place.
6
Use a screwdriver to undo the four screws securing the
cover of the servo, and take each one out.
9
Carefully feed the free end of the cable up through the
circular hole in the servo cover. Make sure that the
cover is the right way up.
10
Fit the cover onto the servo casing, then turn the servo
over and insert the four screws you removed in Step 6.
Tighten them carefully to secure the cover.
7
Carefully lift the cover away from
the other side of the servo.
BE CAREFUL!
Try to avoid
touching the
circuit board
or electronic
components when
you remove the
cover from the
servo.
TIP!
If you chose not to fit the protective pads earlier (at Steps 4 and 5),
you can fit it now, which will help to secure the connector in place.
