43
11
Take the neck stand and make sure the power pack is
turned OFF. Carefully unplug the black servo cable
from the socket on the left of the test board.
HELP!
If the LEDs flash rapidly when
you run the test at Step 14, you
have a faulty connection.
Double-check the servo cable’s
connection to the socket on the
test board, TURNING THE
POWER PACK OFF BEFORE
YOU DO. If the light still flashes,
carefully unscrew the servo
housing and check that the
internal connector plug is in
place. If you pressed the wrong
button, reset the board by
holding down the TEST/SET
switch for several seconds.
14
Press the TEST/SET switch briefly to run the servo test. The shaft at the top
of the servo casing should rotate 45 degrees to the left, stop, then move back
across to 45 degrees to the right. After you have run the test, turn off the
power switch on the battery pack.
CONNECTING THE SERVO
12
Take the right forearm servo with its cable attached.
13
Plug the end of the right forearm
servo cable into the socket you just
removed the cable from.
Units
Tens
15
Familiarise yourself with the lights and switches on the test board. These are used
to set the ID number. Each time you press the UP switch, the ID number increases
by one, and the result is displayed by the two banks of LED lights. The top row
reads in tens and the bottom in units. For example, to set the ID to 18, press UP 17
times. This will light up the 10 LED and the 8 LED. (If you overshoot, press the
DOWN switch to take it down one step at a time.) When the ID number is correct,
you set it by pressing and holding the TEST/SET switch.
