47
11
Align the servo motor with the right forearm frame as
shown. You will need to feed the servo cable through
the large circular hole in the forearm frame and align
the screw holes in the servo with the four circled holes.
8
7
Turn the forearm frame over and check that the hole in
the thumb is in line with the remaining screw hole in the
forearm frame.
Fit an M2 x 5mm pan-head screw through the hole and
carefully tighten it to secure the thumb.
THE SERVO
9
Take the servo motor that you assembled in Stage 8,
and remove all four long screws that secure the rear
cover. Keep the screws safe as you will reuse them.
10
Carefully remove the servo cover. You will not be refitting
this part, as the forearm frame fits in its place.
12
Carefully feed the servo cable through the hole in the
forearm frame.
Servo cable
