52
PREPARING THE SERVO CABLE
9
10
Still holding the parts in one hand, tighten three more of the M2 x 6mm flat-head screws into
the holes lined up in the previous step.
As you have done in previous stages, identify
the side of the servo cable’s connector
marked ‘PUSH’. Then, separate a protective
pad from the sheet (Stage 3) and place this
on top of the connector, making sure that the
pad does not extend beyond the connector’s
tip. Repeat for the connector at the other end
of the servo cable so that both are covered.
Again, make sure
the servo cable is
still sitting in the
recess and that it
is not trapped
between the parts
in any way before
you tighten the
three screws!
7
With the parts held at a 45° angle to one another, line
up the three circled screw holes with those of the
forearm beneath.
8
Once you have the screw holes lined up, hold the parts
together in one hand, making sure that they do not slip
out of position.
45°
45°
Assembled
right arm and
servo cable
Robi’s right arm is nearly complete,
ready to be fitted with another servo
to operate his shoulder movement, and
your next servo cable is protected and
ready for use in the coming stages.
