The options for output configuration will be determined by
what the user has selected for currently assigned channels
in the signal path. If a desired option is greyed out, then
check any previously configured channels and ensure
appropriate output types are set.
Front » Left, Right » High / Mid / Low / Mid-High / Mid-Low / & Full Frequency
Rear » Left, Right » High / Low / & Full Frequency
Center » High-Frequency, Low Frequency & Full Frequency
Subwoofer » Subwoofer Right, Subwoofer Left
Figure 3.6.4
Step 2:
Beneath each channel number is a drop-down
button. Click on the button then select the output type being
used for each specific channel.
Step 3:
After the user has selected all the output signal
paths, click the “Lock Output“ button to lock the channel
output configurations and preven accidental changes.
3.7 Output Delay Adjustments
3.8 Signal Equalizer Adjustments
The
Output Delay Adjustments
area is located left of the
Output
Channel Configuration
area. To make adjustments to delay
settings select the desired channel in the
Output Channel
Configuration
area then input a value for the delay to be added
to the corresponding speaker.
Changes to the equalizer settings can be made in the
Crossover
& Equalizer Adjustments
area located above the
Output Channel
Configuration & Output Delay Adjustments
areas, as shown
below:
Adjustments:
The EDSP4-31BT GUI allows the user to easily
make changes. Use your cursor to drag the slider of the
desired frequency band up or down. Whenever the parametric
equalizer curve is available, each corresponding input
parameter value will be adjusted in real time.
Figure 3..8.1
16
17
