• Ensure that EDSP4-31BT is powered on while the USB
cable is connected to a computer.
• The computer will automatically install and update the
device drivers.
• The EDSP4-31BT software will automatically sink- up
with the on-screen GUI. At this point, in the top left
corner, the
Input Signal Selection and Connection Status
area will indicate green “connected” state.
Note:
EDSP4-31BT can only be connected to a computer
with a USB cable.
3.3 Software Interface
Figure 3.3.1
3.5 Output Channel Configuration
1. Input Signal Selection and Connection Status.
2. Mixer
3. Main Menu
4. Crossover & Equalizer Adjustments
5. Time Delay Adjustments
6. Output Channel Configuration
As shown above in Figure 3.3.1, the software interface of the
EDSP4-31BT GUI is divided into 6 areas:
Step 1:
Select the channel you want to edit in the
Output
Channel Configuration
area of the interface.
- CH1 - 6 are used for full range frequencies
- CH7 - 8 are used for low frequencies.
Step 2:
You can switch between channels to individually adjust
parameters respectively.
Step 3:
Repeat the process with each channel that you wish to
adjust.
3.4 Audio Input Signal Selection
• While connected to a computer, select the appropriate
audio input source in the
Input Signal Selection and
Connection Status
area.
• The input selections are High Level, AUX, Phone and
Player. The audio input signal can be selected from the
audio input drop-down menu. The default source is high
level.
• Each input source signal gain can be adjusted in the
Mixer
area. The adjustable range is 0-40.
12
13
12
13
