69
Issued: 28.02.2005
Strider MD 4 Plus
Troubleshooting
16.3.1 Blink codes
Fault
Cause
Remedy
Release drive lever
Finish your journey as
soon as possible and
charge the batteries
Charge the batteries
(chapter 11.0)
Release drive lever
Visit your dealer
Switch the scooter
off and switch it on
again a few seconds
later.
Charge the batteries
(chapter 11.0)
Switch to drive mode
(chapter 9.0)
Check connecting
plugs at the control
unit (dealer)
Visit your dealer
Drive lever
pressed down
while switching on
Battery voltage
too low
Check battery
charge display
(Batteries
discharged)
Drive lever
pressed while
switching on
drive lever
defective
Automatic switch-
off (overload
protection) active
Check battery
charge display
(Batteries
discharged)
Scooter switched
to push mode
Connecting plugs
at the control unit
interrupted
Fault in
control unit
fault in
magnetbrake
drive lever
defective
... blinking slowly
when switching on
... blinking slowly
during the journey
... blinking slowly,
scooter does not run
... blinking rapidly,
scooter does not run
Drive lever
pressed down
while switching on
Battery voltage
too low
Check battery
charge display
(Batteries
discharged)
Drive lever
pressed while
switching on
drive lever
defective
Automatic switch-
off (overload
protection) active
Check battery
charge display
(Batteries
discharged)
Scooter switched
to push mode
Connecting plugs
at the control unit
interrupted
Fault in
control unit
fault in
magnetbrake
drive lever
defective
Operation indicator blinking (fault display) ...
