background image

13

Maintenance

Operation

1.Once you have used the machine, you are advised to turn off the water tap. (If necessary, pull out
    the inlet hose).
2. Do not  keep the water in tub for a long time. When washing is finished, drain it right away.
3. Once you have finished using the machine, you are advised to unplug it.
4. Put the electric cable and the drain hose in order.
5. Wipe the water on the surface and in tub with a soft cloth and keep the top lid open for a while. It
    helps prevent mould and stagnant smells from forming inside the appliance.

The machine will stop automatically and the 
buzzer will remind you to take out the laundry
or start again.

 

Once you have finished using the machine,
you are advised to unplug it and turn off the
water tap to avoid unexpected leak or fire.

After the end of the programme

Clean the exterior cabinet of the  appliance with a 
soft cloth. Do not use cleanser or volatile chemical 
materials to clean the machine. These  will
damage plastic parts and the surface of the machine.

External cleaning

Clean inlet gate

It is possible that the inlet filter net can be blocked 
by the dust. Please clean it according to the
following steps:
1. Close the tap and turn on the power switch.
2. Start the  washing machine for  5 seconds (let
    the water in the inlet hose flow to the tub), and
    cut off the power supply.
3. Pull off  the inlet hose, remove and clean the

     inlet valve and the inlet net, and install again.

Maintenance methods

If the water in the inner tub has possibility to freeze, please do like below: 
1. In winter, if the remaining water freezes, it can cause the washing machine trouble.
    Please take off the water inlet hose and drain out the water from the hose and inner tub.
2. If the water freezes, please don't operate the washing machine. Put 40

o

C hot water

    in the tub. The hot water should submerge the pulsator. After a few minutes, rotate
    the pulsator by hand gently. Now, you can operate the washing machine.

Magic filter cleaning
1. Pull out the magic filter.
2. Open the box and clean it.
3. Close it and reinstall it.
4. Check if the lint block part is in good condition.

press and pull to take the magic filter out.

lint block part (black rubber)

14

Troubleshooting

It does not drain

It does not inlet

Spinning stops and begins to
supply water during spin
program

Press the program button to 
select SPIN, but it does not work

The spin is intermittent when
spinning starts 

When used for the first time, some 
water flows from the drainpipe

No water supply.
Tap is not open. 
Inlet hose is blocked.

Laundry has been overloaded or underloaded or the machine
is not placed on a stable surface.

Before contacting the technicians, please make the following checks:

Control panel has no display

Plug is not inserted tightly. 
No electricity in the socket. 
Power switch is not turned on.
Power supply is cut off.

Inlet hose leaks

Inlet hose connector (connecting with the tap) is not fixed tightly. 
Inlet hose and washing machine connector is loose.

Drainpipe is not put down.
Drainpipe is bended or blocked.

Because of the remaining water inside, when the factory did the test.

The top lid is closed when the water is draining.

Balance the laundry to reach to the best spin effect.

Phenomena

Possible reason

Summary of Contents for DWT 1470 PL












Reviews: