Dawlance DWT 1470 PL User Manual Download Page 4

Page: 4 / 11

Any objects such as coins, safety pins, nails, screws, stones or any other hard, sharp materials can cause extensive damage and
must not be placed in the machine.

Before washing, please ensure the tap is open and the inlet hose is installed properly.
It is suggested to use low foam washing powder.

Do not put your hands while the machine is working.
It is dangerous even if the speed is very slow.
Take special care of the children and forbid
them to climb onto the washing machine.

It is dangerous to alter the specifications or
attempt to modify this product in any way.

Do not overload the appliance or put any hot
items (such as the kettle with hot water) on the
washing machine.

Garments, which have been in contact with
volatile petroleum products, should not be
washed in the machine.

Keep the appliance away from direct
sunlight and heat sources like the heater.

Benzene

Petroleum

Thinner

This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning the use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.

Cautions

Before using

Please install and adjust the machine according to the requirements of the manual.
It is very important for your safety and correct operation.

Unpacking

Unpack the carton and take out the bottom panel.
Open the top lid of washing machine and take out all the accessories.
Remove all wrappers, including the polystyrene base.
You are advised to keep all the packaging for reuse, in case the machine is to be
transported again.

Installation and adjustment

Before using

Installing the bottom cover

Fixing clamp

Scissors

Bottom cover

The base

To fix bottom cover, first cut the clamps on the
cover and insert the cover in slots present at bottom
in the direction mentioned in picture. Place two
screws at the bottom in the present slot to
permanently fix it.

Positioning

The distance between the washing machine and the wall should be more than 50mm and the
maximum allowed angle of the shank base of the machine is 1 . The slanting or rough ground may
cause unstability or the operation to stop. Please adjust it with the following methods:

Horizontal checking

is in red circle or not. In red circle, it is horizontal.

Adjust the adjustable foot
1.
and twist the adjustable foot.
2. Fasten the nut after adjustment.
3.

is not in red circle,
bubble is in red circle.

Lift up the adjustable foot gently. Now loosen the adjustable nut

repeat the above procedure till the water

Observe, if the water bubble in balancing apparatus

Set the machine flat and observe again. If the water bubble

Adjustable

nut

Adjustable

Fasten