13
14
The machine stops automatically, and music
the buzzer will remind you to take out the
laundry or start again.
Once you have finished using the machine,
you are advised to unplug it and turn off the
water tap to avoid unexpected leak or fire.
After the end of the programme
Clean the exterior cabinet of the appliance with a
soft cloth. Do not use cleanser or volatile chemical
materials to clean the machine. These will damage
the plastic parts and the surface.
External cleaning
Clean inlet gate
It is possible that the inlet filter net can be blocked
by dust. Please clean it according to the following
steps:
1. Close the tap and turn on the power switch.
2. Start the washing machine for 5 seconds (let
the water in the inlet hose flows to the tub), and
cut off the power supply.
3. Pull off the inlet hose, remove and clean the inlet
valve and the inlet net, and install again.
Magic filter cleaning
1. Pull out the magic filter.
2. Open the box and clean it.
3. Close it and reinstall it.
4. Check if the lint block part is in good condition.
Press this part and pull out to take
out the magic filter
Lint block part (black rubber)
Maintenance
Operation
1. Once you have used the machine, you are advised to turn off the water tap. (If necessary, pull out
the inlet hose).
2. Do not keep the water in the tub for a long time. When washing is finished, drain it right away.
3. Once you have finished using the machine, you are advised to unplug it.
4. Put the electric cable and the drain hose in order.
5. Wipe the water on the surface and in the tub with a soft cloth and keep the top lid open for a while. It
helps prevent mould and stagnant smells from forming inside the appliance.
Maintenance methods
If the water in the inner tub has possibility to freeze, please do as below:
1. In winter, if the remaining water freezes, it can cause the washing machine trouble.
Please take off the water inlet hose and drain out the water from the hose and inner tub.
2. If the water freezes, please don't operate the washing machine. Put 40
o
C hot water
in the tub. The hot water should submerge the pulsator. After a few minutes, rotate
the pulsator by hand gently. Now, you can operate the washing machine.
Troubleshooting
It does not drain
It does not inlet
Spin stops and begins to inlet
during spin program
Press the program button to
select SPIN, but it does not spin
The spin is intermittent when
spin starts
First time to use, some water flows
from the drainpipe
No water supply.
Tap is not open.
Inlet hose is blocked.
Laundry is too much or too little or the
machine is not place stably.
Before contacting the technicians, please make the following checks:
Control panel has no display
Plug is not inserted tightly.
No electricity in the socket.
Power switch is not turned on.
Power supply is cut off.
Inlet hose leaks
Inlet hose connector (connecting with the tap) is not fixed tightly.
Inlet hose and washing machine connector is loose.
Drainpipe is not put down.
Drainpipe is bended or blocked.
The remaining water when the factory made test.
Do not close the top lid when drain is finished.
Open up the top lid when start drain.
Balance the laundry to reach to the best spin effect.
Phenomena
Possible reason
Settlement
