3
4
Any objects such as coins, safety pins, nails, screws, stones or any other hard, sharp materials can cause extensive damage and
must not be placed in the machine.
Before washing, please ensure the tap is open and the inlet hose is installed properly.
It is suggested to use low foam washing powder.
Do not put your hands inside while the machine is working.
It is dangerous even if the speed is very slow.
Take special care of the children and forbid
them to climb onto the washing machine.
It is dangerous to alter the specifications or
attempt to modify this product in any way.
Do not overload the appliance or put any hot
items (such as the kettle with hot water) on the
washing machine.
Garments, which have been in contact with
volatile petroleum products, should not be
washed in the machine.
Keep the appliance away from direct
sunlight and heat sources like the heater.
Benzene
Petroleum
Thinner
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities or lack of
experience and knowledge. Unless, they have been given supervision
or instruction concerning the use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
Cautions
Before using
Before using
Please install and adjust the machine according to the requirements of the manual.
It is very important for your safety and correct operation.
Unpacking
Unpack the carton and take out the bottom panel.
Open the top lid of the washing machine and take out all of the accessories.
Remove all wrappers, including the polystyrene base.
You are advised to keep all of the packaging for reuse, in case the machine is to be
transported again.
Installation and adjustment
Before using
Installing the bottom cover
Let the back of the washing machine incline forward. Then
make sure the bottom side cover, with the description sticker,
is to the back of the machine. Then inserted into the bottom
of the machine, as directed by the direction of the arrows.
Remove the two fixing clamps using a pair of scissors.
Insert them accordingly, into the holes indicated by the
blacklines. Gently pull the fixing clamps, make sure
they do not come out. Ensure that the bottom cover is
fixed on the base.
Fixing clamp
Scissors
Bottom cover
The base
Positioning
The distance between the washing machine and the wall should be more than 50mm, and the
maximum allowed angle of the shank base of the machine is 1 . The slanting or rough ground may
cause instability or the operation to stop. Please adjust it with the following methods:
Make it horizontal
Use a tied thread with plumb to check
if it is horizontal.
Adjust the adjustable foot
1. Lift up the adjustable foot gently, loose the adjustable nut
and twist the adjustable foot.
2. Fasten the nut after adjustment.
Loosen
Adjustable
foot
nut
High
Low
Adjustable
Fasten
1
o
