5
USB Connection Installation
reinstall the USB driver. See “Updating USB Drivers” on page 16 for more information.
USB Connection Installation
Complete the local USB connection by using the instructions below:
1. Locate the console or Weather Envoy that will receive the WeatherLink
USB connection.
2.
For consoles only
: Enter the console’s Setup Mode by pressing and hold-
ing DONE, then pressing the down arrow (-). Entering Setup Mode
ensures that the station is not writing any data and saves the current daily
weather information to memory.
3. Remove the battery cover, the batteries, and AC-power adapter, if present.
Note: Failure to remove power to the console or Weather Envoy before installing the data log-
ger may cause damage to the data logger or console. Plugging or unplugging the data
logger while power is applied can lock up or damage the data logger.
4. Carefully insert the USB data logger into the large receptacle marked
EXPANSION
inside the battery compartment.
5. Locate a free USB port on your computer and connect the USB connector
to the port.
USB Port
Vantage Pro or
Pro2 Console
Weather
Envoy
Data
Logger
USB Mini-B
Cable
USB-A