Display Lamp
Weather Monitor II
Page 35
To Program a Customized Scan Routine
1. Press SCAN.
2. Press ENTER.
The compass rose and barometric trend arrow disappear and the word SCAN
appears. After a few seconds, the display will begin to alternate between the
word SCAN and the normal display to let you know you are in scan entry mode.
S
CAN
E
NTRY
M
ODE
3. Press the appropriate keys to display the first function you wish to scan.
For example, press HUM twice and RECL once for High Outside Humidity.
4. If desired, press UNITS to change the unit of measure.
5. Press ENTER to store that function in the scan routine.
6. Repeat steps 3,4, and 5 until you have entered all of the functions you wish to scan.
7. When you have entered all the desired functions, press SCAN.
The customized scan routine will begin. Note that the functions you enter will be
displayed in the same order they appear during the pre-programmed scan rou-
tine, not in the order you entered them.
To Clear a Customized Scan Routine
Press SCAN, then ENTER, then SCAN again.
To Change the Customized Scan Routine
To change a scan routine, follow the instructions above (in “To Program a Cus-
tomized Scan Routine”) to enter a whole new customized scan routine. You
cannot add or delete a function to an existing scan routine; you must re-enter
the scan routine in its entirely.
To Change the Unit of Measure Within the Scan Routine
Change the unit of measure as described in the individual section for the
desired function. Any changes made to the unit of measure outside of the scan
routine are reflected inside the scan routine.
D
ISPLAY
L
AMP
The Weather Monitor II contains a lamp so you can read the display in the
dark. To turn the lamp on or off, simply press any two keys at once.
Note:
Leaving the display lamp on for a prolonged period may cause the inside temperature reading to rise
by 2-4˚F. This will cause a corresponding drop in the inside humidity reading of 4-6%.
OUTSIDE
TEMPERATURE
