4
Safety Considerations
Although your UV system has been manufactured to the highest safety standards,
care must be followed when operating and/or maintaining your system.
1.
Please read the instructions.
- This appliance contains a UV-C emitter.
- Unintended use of the appliance or damage to the housing may result in the escape of
dangerous UV-C radiation. UV-C radiation may, even in little doses, cause harm to the
eyes and skin.
- The appliance must be disconnected from the supply before replacing the UV-C emitter.
- The appliance is intended to be permanently connected to the water mains and not
connected by a hose-set.
2. Before servicing this equipment, disconnect the power cord from the electrical outlet.
3. Energy given off by the UV lamp is harmful to your eyes and skin
. NEVER
look directly at an illuminated UV lamp without adequate eye protection and always
protect your skin from direct exposure to the UV light.
WARNING:
Do not operate
the UV-C emitter when it is removed from the appliance enclosure.
4. The appliance is not to be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction.
5. Children should be supervised so that they do not play with the appliance.
6. The appliance is to be supplied through a residual current device (RCD) having a
rated residual operating current not exceeding 30mA.
7. Maximum working voltage of built-n UV driver U-OUT-250V
8. Maximum operating pressure stated in the instruction manual is 1034 kPa (150 psi).
9. For complete disinfection, use ONLY genuine Microlene replacement parts.
10. Do not operate the unit if it has any damaged or missing components.
11. To avoid possible electrical shock, use only with a properly grounded electrical outlet.
12. Never perform any maintenance to the system unless you are comfortable in doing
so. Contact the manufacturer for service instructions if required.
13. Do not use this system for any purpose other than what it was intended for. Misuse
of this system could potentially cause harm to the user or others.
14. Your system is intended to be installed indoors and away from leaking plumbing.
DO NOT plug the unit in if the system or any of the components are wet. The UV
system should only be installed outdoors if a suitable covering has been installed
to prevent direct contact with the environment (Rain).
15. The disinfection system should be directly installed into a ground fault circuit
interrupter (GFCI). If the use of an extension cord is required, the cord must be
manufactured with a minimum of 1.3mm (16 gauge) wire and care should be taken
to avoid potential tripping hazards.
16. We recommend that a licensed plumber or certified technician install the system.
17. To protect your UV system from the weather, make sure the site is water proof, frost
free and has adequate ventilation. Allow for drainage, to avoid damage to flooring
etc., that over time may occur from leaking pipe joints or seals.
