!
,!
Setting and Operating Your
EcoSalt
REDOX System
5. If the green
'
Within Range
(
LED indicator is not achieved during your daily filtration cycle, you need to either
increase the filtration time or follow the trouble shooting procedures on page 16.
6. Whilst the pump is off there will be no flow and the red
'
No Flow
(
LED will be displayed. This is normal, in this
state the ORP REDOX LED may indicate
'
Under
(
or
'
Within range
(
or
'
Over
(
. There is some overlap of the
ORP REDOX LED
(
s
-
it is possible for the
'
Within Range
(
and
'
Over
(
or
'
Under
(
LED
(
s to be on at the same
time.
7. The green
'
Cell Power
(
LED indicator will only operate when the system is actually producing sanitiser.
8. If the red
'
Add Salt
(
LED indicator is displayed you need to top up your salt level to at least 4,500ppm. The
'
Add Salt
(
indicator is also affected by water temperature, as is the unit output. The EcoSalt REDOX is
designed for optimum operation with 20-30
!
C water temperature. If water temperature is less than 20
.
C you
may require additional salt to turn off the ADD SALT Indicator.
9.
What is ORP?
EcoSalt REDOX uses an ORP Probe to determine whether or not chlorine needs to be produced to sanitise the
pool. ORP levels are measured in millivolts (mV). The ORP Probe does not measure the actual chlorine level of
your pool, it measures the effectiveness of the chlorine to oxidise and kill biological contaminants.
Note:
It is possible for two pools with identical chlorine residuals to have very different ORP levels. This is due to
the effectiveness of chlorine in a pool being reliant on other factors such as pH, stabiliser levels, total dissolved
solids (TDS), combined chlorine levels and temperature.
In general ORP will be affected in the following ways:
Chemical Level
ORP Level
Chlorine
UP
UP
pH
UP
DOWN
pH
DOWN
UP
Stabiliser
UP
DOWN
Combined Chlorine (Chloramines)
UP
DOWN
Total Dissolved Solids*
UP
DOWN
Temperature
UP
UP
* TDS other than Salt
10. Please note your EcoSalt REDOX Cell is a reverse polarity type designed to clean itself periodically. To
clean itself the EcoSalt REDOX will shut down for a few minutes and then reverse the polarity of its cell
plates. In hard water areas you may need to remove and clean the cell manually, following the cleaning
instructions provided on page 12.
