DATSUMO Labo Home Edition, Instruction Manual

Page: 10 / 20

※
Diagram 1
※When the Intensity level is changed, the
next shot right after changing will still
be the previous Intensity Level. Thus,
do an empty shot by placing fingers on
the long sides of the surface and press
the SHOT button (refer picture to the
right). Bright light will be released so
please do to direct the surface at other
people or look directly into it.
※ If the glass surface does not touch the skin
How to Use
The glass surface must be cleaned each time before usage. See the “Product
Maintenance” section on page 14 for detailed cleaning instructions.
From the “Skin Tone Chart” on page 10, select the Intensity Level that suits you
(press and hold the POWER button to change the Intensity Level) and use it
while carefully observing the skin condition and its response.
How the skin reacts to the product light differs according to the skin health
condition and type. Please pay special attention after sunburn. (See page 3)
Hold product at 90 degrees, with product surface vertically against the skin.
READY LAMP
SHOT BUTTON
When the READY Lamp on the product
lights up, it signals it is ready for usage.
When the surface is in contact with the skin
the READY Lamp light will start flashing to
indicate that you can start using the SHOTS
properly, the READY Lamp light will not flash.
※ It can take up to 3 to 5 seconds per SHOT.
※ Even if the READY Lamp flashes but no shots
appear when pressed, please refer to page 15.