Datex-Ohmeda F-LM1, Technical Reference Manual

Page: 87 / 377

Planned maintenance
35.
Check that the monitor connects to the Datex-Ohmeda Network, i.e. the network symbol
is displayed on the upper right-hand corner of the screen.
A message regarding the connection to Datex-Ohmeda Central should appear in the message
field on the screen.
36. Check in the Monitor - Communication service menu that:
− the “location ID number” matches with the ID plug connected to X3
− the packets and bytes IN is increasing slowly
− the packets and bytes OUT is increasing fast
− “connections” shows the names of the connected networks
− the counters for data errors (“CRC”, “Frame”, “Transm.”) are stable
NOTE: The counters may show values greater than 0. However, any values increasing
continuously indicate a problem.
37. Check that the counters for hardware errors (“Intern.”, “Missed”, “FIFO”, “Overrun”) all show 0.
"
2.8 DataCard test
Insert a DataCard labeled “Data” in the DataCard slot. Check that the message “Data Card
inserted” appears in the message field and the DataCard symbol is displayed on the
upper right-hand corner of the monitor.
"
2.9 Service Log
38. Check the Service Log for possible problems. If the monitor contains a recorder unit, record the
Service Log onto the recorder by selecting
Record Log
.
39. Clear the content of the Service Log by selecting Reset Log from the menu.
"
2.10 Electric safety check
40. Perform the electrical safety check and leakage current test.
41. Check that the monitor functions normally after the performed electrical safety check.
42. Switch the monitor to standby, disconnect the power cord and perform final cleaning.
43. Fill in all necessary documents.
"
7
Document No. 8001934-2