Datex-Ohmeda F-LM1, Technical Reference Manual

Page: 86 / 377

Datex-Ohmeda S/5 Light Monitor
Invasive blood pressure measurement tests
26. Check the InvBP channels with a patient simulator. The values and waveforms should
correspond to the simulator settings.
Note: In case you evaluate the measurement accuracy with the simulator, add simulator's
accuracy specification to the one of the monitor.
"
Mainstream CO
2
test
27. Enter the CO
2
service menu and check that the “Timeouts”, “Bad checksums” and “send queue
full” values are not increasing faster than by 50 per second.
28. Check that the message “No CO
2
sensor” is displayed when there is no CO
2
sensor connected.
Connect a CO
2
sensor to the monitor and check that the message “warming” is displayed.
29. Wait until the “warming” message disappears and the CO
2
value appears on the screen.
Breathe at least 5 times to the CO
2
sensor adapter and make sure that the measured values are
reasonable and the Respiratory value is calculated.
30. Perform the CO
2
calibration check if necessary.
"
2.5 Trend test
31. Check that the monitor is capable of storing the trend information and temporary settings over
2 minute standby.
"
2.6 Recorder unit test
32. Open the paper compartment cover. Check that the message ‘Recorder: Cover open’ appears
on the screen, then close the cover.
33.
Push the “Recorder Start/Stop” button on the recorder unit and check that the recorder starts
recording the selected waveforms. Push the button again to stop recording.
Check that the quality of the recordings is acceptable.
"
2.7 Network test
34. Check that the Mon-Net cable connector and the Identification plug are clean and intact, then
connect them to the monitor.
Document No. 8001934-2
6