S/5 Keyboards
Document No. 8001589-1
6
3
SERVICE PROCEDURES
3.1
General service information
Field service is limited to replacing faulty PC boards or mechanical parts. The PC boards are then
returned to Datex-Ohmeda for repair.
Datex-Ohmeda Technical Services is always available for service advice. Please provide the unit
serial number, full type designation and a detailed description of the fault.
CAUTION
The tests and repairs outlined in this section should only be attempted by trained
personnel with the appropriate equipment. Unauthorized service may void warranty
of the unit.
3.2
Service check
These instructions include complete procedures for a service check. The service check is
recommended to be performed after any service repair. However, the service check procedures can
also be used for determining possible failures.
The procedures should be performed in ascending order.
The instructions include a check forms (
Appendix A-B
) which should be filled in when performing
the procedures.
The mark
?
in the instructions means that the check form should be signed after performing
the procedure.
The procedures are designed for monitors with S/5 monitor software of revision 01. However, most
of the procedures also apply to monitors, which contain some other monitor software
type/revision.
3.2.1
Recommended tools
Tool
Order No.
Notes
•
Central Unit
•
•
•
Screwdriver
•
•
3.2.2
Command Board, K-ANE/K-ICU and Command Bar, K-ANEB/K-ICUB
•
Turn the monitor to STBY.
1.
Disconnect the command board cable from the display controller board.
Check that the connector pins of the cable are clean, straight and at about the same height.
Check that the cable is intact. Check that the locking screws inside the connector case are
intact.
Leave the cable disconnected.
?
Summary of Contents for AS/3 K-ANE
Page 2: ......
Page 28: ...S 5 Keyboards Document No 8001589 1 24 ...
