Dateq Qfm, User Manual

Page: 12 / 16

EN
Configuring Qfm manual
6
Connecting the tuner
Select ‘Connection’
Æ ‘Connect’, or push F10, to establish the connection to the
system.
Adjusting presets
Entering the presets with the PC
software select the menu ‘Qfm’
Æ
‘Show presets’, or press F8.
The configuration window is
opened. Select the preset and
enter the new frequency with the keyboard. Press <enter> to store.
The field ‘station name’ can hold the optional station name. This will be showed when
the preset is changed.
The tuner can be switched to mono. This can be useful when there is a poor
reception.
When all the presets are entered press ‘Upload’ to store the new presets in the tuner.
With the box ‘Keys on front enabled’ it is possible to enable or disable the keys.
When the state is toggled the status is updated immediately.
Configuring the logical outputs
Press F9 in the main-screen. The output-
configuration window will be opened.
Each tuner has a logical output, so output 1 is
controlled by tuner 1, output 2 is controlled by
tuner 2 and so on.
The outputs can be made active when:
•
The signal strength is greater/ lower than a
given value,
•
The radiostation has a stereo-pilot or not,
•
PTY (program type) is equal to/ or not equal
to a given value,
•
The radiostation does transmit RDS info or
not,
•
The radiostation transmits traffic info or not,
•
Export the PTY-info,
When this option is selected the other three outputs cannot be configured
anymore; the PTY-info of this tuner will be showed on the outputs. See the table
below.