Datecs EP-50H, Service Manual, Page: 9 / 40

9
Service Manual
5. Detaching the Upper Cover
y Lift the upper cover from the rear of
the printer body. When this is done,
lift it gently.
y
Disconnect all the connectors. Holding up
the upper cover, disconnect all the connectors
rom the control board. Hold the base of the
connector to disconnect it. Pulling the cable will
ap it.
y
Disconnect the FG cable. Remove one
M3
×
8 (BT) screw used to secure it to the
control board.
y
Detach the upper cover.
6. Detaching the NPE Sensor Unit
y
Remove one M3
×
10 (BT) screw used
to secure the NPE sensor unit.
y
Pull out a cable.
7. Detaching the Operation Panel Board
y
Remove two M2.6
×
8 (BT) screws. Turn over
the upper cover and unscrew the operation
panel board.
y
Detach the operation panel board.