Datecs EP-50H, Service Manual, Page: 10 / 40

10
1 DATECS
LP/EP-50H
8. Detaching the Printer Mechanism
y
Remove four M2.6
×
8 (BT) screws used to
secure the printer mechanism. Remove
two screws each from the front and back.
y
Pull out the printer mechanism. Pull it out
gently to the paper holder side (front) without
pulling a cable.
If the label sensor is attached, separate it from
the printer mechanism.
9. Detaching the Control Board
y
Remove one M3
×
8 (BT) screw.
y
Turn on the Power switch.
y
Detach the board. Slightly opening outside
the plastic part near the Power switch,
slide it upward to the near side of the
printer body to detach.
10. Detaching the shielding plate.
* For Steps 5 to 9, carry out only those required for maintenance.