Datcon DT2500 Series, Operating Manual

Page: 13 / 29

DT2500
20171220-V1
13
5.3. Connecting the power supply
The following figure shows the power supply connection to devices.
Wiring plan, connecting
the power supply
(see also “Application
example”)
Be careful the polarity of
the cables
The power supply should be operated only from 10 A overcurrent
protection provided power network.
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to the wiring
plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on them firmly.
Checking the
connections
Check if the cables are connected properly (have you connected all
the cables, have you connected to the right place, do not the cable-
ends touch each other).
5.4. Put the instrument under power supply
Put the instrument
under supply voltage
After you have completed the connections, put the instrument under
supply voltage. If the connection is correct the green indicator gives
light and you can measure on output the output voltage.