Datcon DT2500 Series, Operating Manual

Page: 12 / 29

DT2500
12
20171220-V1
5.2. Connecting the load unit to the device
The following figure shows the load unit connection to devices.
Wiring plan, connecting
the load
(see also
“Application example”)
Be careful the polarity of
the cables
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to the wiring
plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on them firmly.
Checking the
connections
Check if the cables are connected properly (have you connected all
the cables, have you connected to the right place, do not the cable-
ends touch each other).