
ADIO WIRELESS BRIDGE USER’S MANAUL REV. 02
15
Main
command
Function Command
Name
Command Description
Default
Value
Value Range
io.txrate
Sets the sample and RF transmission
rate. This command must be enabled
for I/O line passing
0
50 – 1800000
ms
io.dataout
Sets the output data format to either
text or JSON format.
Text = 0, JSON = 1.
1
0 or 1
io.name
Allows for a user settable string of up
to 20 characters. Zeros are sent for all
characters that are not set
0
Any 20
characters
pkts.en
Enables JSON output format when
used with an ADIO Wireless Bridge
when en = 1
0
0 or 1
store
Stores settings to non-volatile
memory.
NA
No parameters
uart.rate
Changes the host to internal radio
baud rate. This command should be
used in conjunction with changing the
radio baud rate.
9600
1200 - 115200
ver
Displays loaded firmware version
NA
No parameters
Fig 10. List of ADIO Wireless Bridge Commands
Figure 10 shows a list of commands available to set with the ADIO Wireless Bridge. As with other
Wireless Bridge devices, networking modes can be set by using the commands available on the internal
Digi XBee radio module. Channel tokens can isolate I/O line passing, but additional network commands
can be used to further isolate different networks of devices. Common Networking commands are listed
below.
ID – Controls the network identification number
CH – Channel (Frequency) of the XBee radio.
DH & DL – Sets the destination address. For point-to-point mode DH & DL on Radio A should be set to
the SH & SL values of Radio B and vice versa.
See the XBee S2C manual and X-CTU program for complete details.
XBee S2C Users Manual
https://www.digi.com/pdf/ds_xbee-s2c-802-15-4.pdf
X-CTU Program – Digi’s XBee Configuration and Test Utility
https://www.digi.com/products/xbee-rf-solutions/xctu-software/xctu