7
Rear Panel
Tally Input Connector Information
Pin Assignment
D-Sub 15pin Female
The pin assignment of the Tally Connector is shown in the following table:
Panel / Source
On Air - Red LED
Standby - Yellow LED
A / 1
Pins 1 & 4
Pins 3 & 14
B / 2
Pins 6 & 4
Pins 8 & 14
C / 3
Pins 11 & 4
Pins 13 & 14
D / 4
Pins 5 & 4
Pins 15 & 14
Powering On
Connect the TLM-434H power supply to the DC In socket. Ensure the power cable is connected to a suitable
mains socket.
Switch the power On/Off switch to the ON position and all 4 panels will become active.
SDI / HD-SDI input and Bypass
BNC connector for SDI / HD-SDI Input and Bypass / Loop through.
Bypass / Loop through BNC connector only works with SDI / HD-SDI input.
HDMI input
HDMI digital signal input connector.
Support HDMI 1.1
15Pin D-Sub Tally Input
Send in red and yellow colour tally signal to tally LED. Red means on-air, yellow means
standby. See below table.
DC in socket
Connect the supplied 12V 3A PSU to this socket. The connection can be secured by
screwing the outer fastening ring of the DC In plug to the socket.
