2
Holder Assembly
Step 1:
Lay the base flat on a hard surface.
Step 2:
Place the side bar vertically on top of the base (outer
placement).
Step 3:
Place the washer onto the screw, and insert the screw
through each of the 8 bottom holes. Secure the screws with nylock
nuts.
Step 4:
Repeat steps 2 and 3 for the second side bar.
Mounting the Units
Step 5:
Slide the Tinnerman clips onto the sidebar over the holes.
Step 6:
Starting from the top of the holder, place the TLM-702
monitor on top of the Tinnerman clips.
Step 7:
Place the washer onto the screw and insert the screw into
Tinnerman clip to secure the monitor in its place.
Step 8:
Place the ITC-100 intercom on top of the Tinnerman clips
right below the monitor.
Step 9:
Place the washer onto the screw and insert the screw into
Tinnerman clip to secure the intercom in its place.
Step 10:
Place the DN-500 recorder on top of the Tinnerman clips
below the intercom.
NOTE:
You may have to wiggle the unit a bit to
slide it in the holder.
Step 11:
Place the washer onto the screw and insert the screw into
Tinnerman clip to secure the recorder in its place.