Datavideo NVS-34, Instruction Manual

Page: 10 / 64

10

Push and hold one of the RECORD and STREAM buttons until the pushed
button starts blinking red.

As soon as the pushed RECORD or STREAM button is released, the BITRATE
button will turn solid red.

While the BITRATE button stays solid red, push it to switch between different
bitrate modes (H, M or L). Please note that the BITRATE button will return to
solid white after a few seconds if button push is not sensed.

To exit, push the the RECORD or STREAM button again.
Note: The system will return to the previous setting if the BITRATE button is not
pushed. The default bitrate is M.
H/M/L LED Indicators
ON (Green)
: Bitrate mode enabled
OFF : Bitrate mode disabled
RECORD Button
The RECORD button activates and deactivates the RECORD Only
mode; follow the steps outlined below:
Start recording

When idle, the RECORD button is solid white.

Press and hold the RECORD button for approximately 2 seconds.

When the record function is activating, the RECORD button turns from solid
white, then blinking red and finally to solid red.

When the RECORD button turns solid red, this indicates that the record
function has been successfully activated.
Stop recording

While recording, the RECORD button is solid red.

Press and hold the RECORD button for approximately 2 seconds.

When the record function is terminating, the RECORD button turns from solid
red, then blinking red and finally to solid white.

When the RECORD button turns solid white, this indicates that the record
function has been successfully terminated.