Datavideo CG-100, User Manual

Page: 135 / 141

135
Q & A
1. Q: Sometimes there are flickers or black edges when I use 1 or
2 on “Speed” in Crawl or Roll effect?
A: This issue is caused by the TV standard (NTSC, 480i,
interlace). You could select a higher number (Slower speed) to
resolve this problem.
2. Q: Once I have clicked on “PLAY”, why can’t I jump to the
specific page I want?
A: That’s to avoid the user accidentally clicking on other functions
while the program is on air. You could rearrange the pages into the
sequence you desire; and then, click on the “PLAY” button.
3. Q: Why do some pages of texts, or graphics not show up when I
click on “PLAY”?
A: Please check if you have set up an effect on them. When you
click on “PLAY” mode, it will play those pages’ which have an
animation sequence assigned. Therefore, if you don’t have any
effect selected, they will not show up when you click on “PLAY”. In
this case, if you do not want any moving effect, you could select
“DISPLAY” on or off.
4. Q: Why do I sometimes see a black dot or a gap between the
character and its outline?
A: It usually happens when you mix Red, Green, or Blue colors in
the character itself and also the outline. Due to TV standard, this
problem might occur. It is best not to use pure red, green and blue
as the character and outline colors at the same time.
5. Q: Sometimes when I set the outline as 1, I can see a saw tooth
on the TV screen.
A: This is another issue caused by TV standard (interlace). When
it happens, it is best to make the outline larger than 4.