Datavan ARC Series, User Manual

Page: 33 / 42

HARDWARE INSTALLATION
33
Installing the Secondary LCD Display (Optional)
WARNINN:
Be sure to turn off the power of the Touch Terminal before making any
connection or disconnection.
1. Remove the connectors cover. (a)
2. Place the Touch Terminal on a soft and flat surface, with the LCD panel facing down. Then
adjust the stand to full upright position.
3. Remove the two screws securing the dummy cover on the stand arm. (b)
4. Remove the dummy cover. (c)
5. Remove the stand arm cover. (d)
6. Remove the five screws securing the bottom of the stand . (e)
7. Remove the top stand cover. (f)
8. Remove the four screws securing the bracket to the stand arm. Then remove the bracket.
(g)
9. Connect one end of the USB extension cable to the USB port of the Touch Terminal. (h)
10. Route the USB extension cable through the hole on the bottom of the stand, and the other
end through the hole on the bracket and stand arm. Make sure to leave at least 10 cm of
excess cable for easy cable routing and connection.
(i)
11. Secure the bracket with the four screws. (g)
12. Install the top stand cover. (f)
13. Secure the bottom of the stand with the five screws. (e)
14. Align and install the connectors cover. Make sure to push the connectors cover firmly until it
clicks into place. (a)
15. Align the stand arm cover, and then push the stand arm cover inward until it is fully seated.
(d)
16. Route the secondary LCD display’s interface cable through the cable clip on the bracket.
Then push the revealing parts on the connected cables into the cable compartment. (j)
17. Connect the secondary LCD display’s USB cable to the extension USB cable connector. (k)
18. Align the screw holes of the secondary LCD display bracket with the screw holes on the
stand. (l)
19. Secure the secondary LCD display to the Touch Terminal with the two screws. (m)